Hi we have a BR1 transmitter on the wall under the boiler. This morning a red light has started to flash. Its just a new boiler etc (only 2 weeks old) and we've no idea what it means. Anyone help a confused peron!??
Turn remote to auto and run
Press reset on the wall for 4 sec till light flashes
Press set on wall till the light flashes
Press learn on back remote
Press test on the back of the remote
Boiler should start to work
Press learn again to turn it off test mode
Hi will this work for the brtrt model as I have fitted two next to each other and they have been working for over a year fine but have now decided to play up one leaves the heating on and the other one won't come on.i will try resetting them both do you think because they are next to each other that are interfering with each other.i rang the manufactures and they told me they should be 50cm apart from each other and they probably haven't worked properly from the start.
Remove the thermostat.
Then at receiver, press 'reset' for 4 secs. Then press 'set'
On thermostat press 'learn'.
The green light will flash, then go off, after 20 secs, it will illluminate. If it goes red, you have a fault