Our washing machine no longer spins. I've checked the carbon brushes, but they still have a few cms left.
No error is shown (only the software no. (15 10)) when I enter test mode.
It fills and drains fine and the filters and belt are OK too.
Any suggestions?
The start and cancel button is the same button (cancel is hold for 3secs).
The only preset 90degree wash is the baby & toddler clothing. It doesn't do anything on this setting.
The start and cancel button is the same button (cancel is hold for 3secs).
The only preset 90degree wash is the baby & toddler clothing. It doesn't do anything on this setting.
Turn power button off (not at wall)
Select 90 degree wash
Press Start and Cancel button down at same time for 3 seconds and turn power button on whilst still holding buttons down - Start light will flash.
Leave power on.
Select any Spin position.
Press Start and Cancel button at same time again for 3 seconds - other buttons may start to flash - if they do, press Start and Cancel button together again for 3 seconds.
Machine should be re-set ready for use.
Information posted by users should be considered for general guidance only. Users act, or refrain from action, on the basis of such information entirely at their own risk.
fixed4free.com does not endorse any of the information supplied on this website by users.