aritech AS256 indoor alarm siren?

thanks very much i will go for the elmdene speaker. cheers :)

john
January 2015

Yes now obsolete.

You have a good panel there mate and yes wire the elmdene to the two siren terminals on the panel;A/T terminals are the tamper pair for the internal speaker also which are most likely in use with the AS2256.

Elmdene is a great speaker and very loud.

e manno
January 2015

i take the as256 is well obsolete then?. not sure about the 16 and 17 tamper terminals. my system is a scantronic 9600 and the aritech as256 siren was connected to the speaker terminals ( marked siren). surprisingly it did work all these years with no problems.

so should i just order a 16 ohm alarm speaker say a elmdene. will the volume be the same? thanks

john
January 2015

No but you could fit any 16 ohm internal if you wish wouldn't bother with the tamper pair either.
Iirc. 16&17 are the tamper terminals at the panel for the int siren so you could fit link then use +&- to drive the speaker.

I'd check with the manual on the terminals but I'm sure there's tamper pair and +&- for the internal :)

e manno
January 2015