|
|
|
|
|
|
|
|
|
|
All you have to do is remove the exit covers and the exit cover above the exit opening, then the op panel (one screw) then you now have access to the front of the fix assy screws, next remove the cover holding the left platen glass, remove the glass, remove the black plastic piece holding the cable in place, slide the platen over until the access hole lines up with the rear fix assy screw and now you have access to the rear of the fix assy screw. unplug the fix assy wires and remove fix assy through the exit side of machine. takes about 5 minutes.
Ernie April 2008 |
|
|
|
|
|
|
|
|
All you have to do is remove the exit covers and the exit cover above the exit opening, then the op panel (one screw) then you now have access to the front of the fix assy screws, next remove the cover holding the left platen glass, remove the glass, remove the black plastic piece holding the cable in place, slide the platen over until the access hole lines up with the rear fix assy screw and now you have access to the rear of the fix assy screw. unplug the fix assy wires and remove fix assy through the exit side of machine. takes about 5 minutes.
Ernie April 2008 |
|
|
|
|
|
|
|
|
If you send me your email address or a fax number, I can send you the instructions straight out of the service manual. Otherwise it is way too complicated to describe the process in this space. You basically have to remove the back metal plate, both sides of the unit need the plastic covers removed along with the control panel assembly. This gives you access to remove the document feeder assembly (that great big thing on top that you put the documents in that slides back and forth.) Once the ADF (automatic document feeder) is removed, you have access to the screws that hold the fixing assembly in place. Once the screws are removed, there are three electrical plugs on the fixing assembly that need to be removed, and fixing assembly slides out the left side of the unit. Installation is just the opposite.
Thomas
parkranger68@yahoo.com
Thomas October 2007 |
|
|
|
|
|
|
|
|
Add your answer using the form below ...
|
|
|
|
|
|
|
|
|
|
|