|
|
|
|
|
|
|
|
|
|
Does anyone have a user guide for a Concept 6 alarm panel?My alarm needs resetting and unfortunately I do not have a manual and no idea how to re-set it? if anyone had a pdf version of the manual or knows where I can get one that would be great.
Thanks!
Lisa McGinty August 2007
|
|
|
Click here if you can answer this question |
|
|
|
|
|
Lisa
On the Concept I have, you can reset it by doing the following...
Remove mains supply (switch fuse box off?), either it'll power off (no backup battery, or battery dead) or stay on - battery ok(ish!). Remove control panel cover to cause an alarm.
Disconnect battery. (if self-contained bell/sounder, this will go off)
Remove any cables from terminals 13 and 23 (remember to label them, so you know how to put them back!)
Fit a wire between 13 and 23.
Apply power (switch mains on)
System should power up with no alarm. Remove wire between 12 and 23.
Refit cover, and check tamper light goes off.
(Manual says) When all circuits are clear, system will go into Day Mode - I'm not sure what this means, but I reset mine ok.
System will be reset, and Customer Code will be set to 0123.
Hope this helps,
Richard
Richard Thorp August 2007 |
|
|
|
|
|
|
|
|
I have - and I've just rewired it.
Can send a copy if u email.
richard_j_thorp@yahoo.co.uk
Richard Thorp August 2007 |
|
|
|
|
|
|
|
|
Add your answer using the form below ...
|
|
|
|
|
|
|
|
|
|
|