Kenmore 70 series wont spin in rinse, will start spin if on/off pulled?
Hi
I have a Kenmore 70 series Heavy duty model 110. I acts normal until spin cycle then won't spin. If I restart by pulling on/off it will start to spin. I might also be starting to make a different noise during spin cycle. What is the problem?
Had to break down & call the repairman. Weird noise was a little metal kitchen skewer that had been sucked into the pump. Pump ok but had to replace punctured drain hose. They replaced the gear case under a 5 year warranty for that part-Whew part would have been $252!
Irene Crouse
October 2005
I had the same problem...Called Sears repair...Said they don't have a belt...That the clutch was out...Wanted 262.00 to fix it...I'm going to buy a new one...I hate waiting and listening for it to spin so that I can go boost it off...Good luck...The repairman said there is a lot of 70 series that has that problem...
mwood2@comcast.net
September 2005
First check the belt for wear and tension. Replace belt or tighten . The tub clutch plate may be worn or oil soaked causing it to slip.
ken davison
September 2005
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
