I have obtained an offcut of Laminate Worktop to fit in a study. One end of it it quite rough and bare, is there a way I can relaminate(?) that end and make it presentable?
you just need an edging strip i.e. a strip of laminate in the same colour. This is applied to the particleboard surface using adhesive then trimmed with a craft knife.
If you cannot source a piece of matching laminate trim, from your local hardware store, the also sell aluminium end caps i.e. a piece of alluminium which simply screws to the end to finish the top
M
February 2009
Brilliant! Thank you both for your help.
Terry
February 2009
Use Google Images
enter worktop end cap
See what you need
peccavi
February 2009
Depends on the pattern on it but there's a high chance of you getting a strip of stuff (or something that might blend in) to stick on the end from the likes of B&Q or a local joiner may have some. Comes in a roll a bit like sellotape. You would probably need to sand your end flat first and make sure it's dust free before gluing though.