how do i change the cord in a talon whippersnipper?

Not sure if all models are the same , but my Talon, you have to cut a single length of cord off, 5 Meters long, , * align the arrows on the inner and outer spool, *while pushing the inner spool down , insert one end of the cord through eyelets into feed slot on spool divider, ensure the line enters the feed slots. * Push line until approx. 5cm of line appears from below bump knob. * insert both line endsinto locking hole, pull line at eyelet to tension. * once both ends secure and locked in place, turn the inner spool counter clockwise in direction of the arrows to load line. * once all line spooled on, cut the remaining loop in half, then you are done.! But it is a right S*** of a thing to do, actually this product is not the best line trimmer on the market, guess u have worked that out like me by now.... now back to my problem my starter cord is broken, and cannot work out how to replace it !!!!

Neville - Sydney
December 2008

good question...i think its stupid how they've designed the talon wipper snippers slashing cord!!! someone plz answer this question

joe
August 2007

i need to change the cutting cord in my talon

geoff walker
October 2006