Got it now...Remember ............Check the continuity of the thermostats attached to the heater wiring. These are the two white discs above the heater element.( Check this before you buy a new heater as you will not need to buy the heater if this is the cause of your problem.)
Remove the side panel from the machine as well as the rear panel and since the heater comes with the wiring attached, carefully remove the old heater by unclicking from the positioning slots. Position the new heater and replace the wires as you take off the old ones. Do the one that goes though the rear slot first and clip into the harness. The wires DO NOT need to be cut as there are spade connectors on them. Carefully do a check to see if the dryer heats up before you replace the panels etc.
The man at my local parts shop was very helpful and talked me through the job.
Jean
Jean Walker
July 2007
howtomendit.com for free repair help, information and advice.
