|
|
|
|
|
|
|
|
|
|
ADE Accenta SL8 G3 mini panel?I am unable to reset this back to factory conditions according to the Eng Manual instructions, its been powered off overnight and reset(x2) within 5S and no joy at all. Board manuf'd Nov 99.
The main problem is that it will not auto 'set' (timed), and will not let the entry/exit times be programmed (flat beep) and will not 'full alarm' after entry through timed entrance, it triggers but then just carries on beeping way beyond 90 seconds (about all that I can be patient for).This means that the problem is probably in the timer section somewhere. If I could get it back to factory settings I would probably be able to resolve it. Is there another way to do this ? Perhaps some magic 3 button salute or something? Grateful for any help. Thanks.
VikTex August 2008
|
|
|
Click here if you can answer this question |
|
|
|
|
|
My 21 month old daughter (whilst being held by her absent minded grandmother I hasten to add!) has seemingly had a field day with our Accenta SL8 G3 key panel. Now, everytime we open the exterior door, we get a two tone chime similar to that experienced when entering a corner shop and also enjoy a loud beep everytime we walk past any sensor in the house, whilst illuminating the zone violition lights up like Blackpool.
Cant seem to reset it and the technical support number on the back of the manual is no longer accepted. At the moment, resorted to sticking Post-It notes on the sensors to avoid going mad as we walk around our house. Any pearls of wisdom would be fabulous!! Thanks in advance!
Alan July 2011 |
|
|
|
|
|
|
|
|
i have an sl8 intruder alarm system main box ok but outher control box flashing on and off on main panel is battery needing replaced or what is problem
alan sprott June 2009 |
|
|
|
|
|
|
|
|
We have electricity cuts often. I keep resetting the alarm but I think the battery needs replacing. Any ideas how I can get hold of a "Rechargable 12 V-2.1Ah" battery for a SL8 G3?
Sassan February 2009 |
|
|
|
|
|
|
|
|
switch of mains to panel open panel disconect the battery ,switch mains back on press reset twice ,reconect battery put lid back on panel press 0123 reset,this should work ,if not power down panel open panel lid remove battery ,look along the bottom of ,p,c,b you will see terminal marked p,a ,.also at the right hand side a terminal marked set +,remove cable from left hand p,a terminal ,fit a link of wire brtween left hand p,a to set + ,power panel back up ,refit original cable to left hand p,a .refit battery and put lid back on ,when all the zone lights go of the panel will beep,this will now be back to factory settings .hope this helps.any questions just ask
brad September 2008 |
|
|
|
|
|
|
|
|
Add your answer using the form below ...
|
|
|
|
|
|
|
|
|
|
|