|
|
|
|
|
|
|
|
|
|
How can I switch off my Accenta Alarm?I have an Accenta 8 Alarm which went off at 3.00 am today. I have now managed to stop the alarm beeping but the light is still flashing which I feel may cause problems tonight. It seems to have a mind of its own as I disconnected the battery and pulled out all the fuses but it was still beeping, I then put all the fuses back except the left hand one of the bank of three and the beeping stopped. I inend taking off the wall Alarm completely when the weather gets warmer but want to ensure that I don't get another disturbed night and that my neighbours don't get disturbed either,
Alan January 2010
|
|
|
Click here if you can answer this question |
|
|
|
|
|
Thanks Death,
I'll have a go this weekend, just had a quick look but can't see any markings, will seek out a torch tomorrow and have a closer look. Many thanks for the advice.
Alan
Alan February 2010 |
|
|
|
|
|
|
|
|
it should say tamp on the board like z1 z2 then you should see tamp in the panel or ta
Death
Death February 2010 |
|
|
|
|
|
|
|
|
Hi Death,
Thanks for the note, I'll leave it untill the weekend thats if the weather warms up. Its a funny thing but during today the flashing light on the bell box stopped so all is well at the moment but the thing seems to have a mind of its own and it wouldn't surprise me if it started up again. One thing , how do I find the tamp wires, the main box is just full of wires, would it be one of the thicker wires or the very thin ones
Alan
Alan February 2010 |
|
|
|
|
|
|
|
|
oh no you have the tamper such a pain this is normally the bell box but first open the main panel in your house and find tamp and it could have two wires going into the two terminals on tamp unscrew the wires pull them out so its 2 empty terminals and on the wires that you pulled out cut 4 cm of any of the wires and loop it into the 2 terminals and replace the lid oh and when you opened the lid it may of sounded when you re fit the lid press reset and see if theres any difference if not go up to your bell box and the alarm may sound so watch out there shold be a metal thin bar that pushes in and out that is the tamper switch just bend it a little bit and replace the lid
let me know if it works
p.s on the main panel strech the spring and dont worry about the flashing light if your planning to do it next weekend just press reset for now
Death
Death January 2010 |
|
|
|
|
|
|
|
|
Hi, Thanks for the reply. The Tamper light is showing on the keyboard, I don't have any light showing on the main board.
Alan
Alan January 2010 |
|
|
|
|
|
|
|
|
hi alan the accenta series are a pain when your alarm goes off does anything indicate like tamper or PA or anything
Death
Death January 2010 |
|
|
|
|
|
|
|
|
Add your answer using the form below ...
|
|
|
|
|
|
|
|
|
|
|