 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Dishwasher filling with water (Bosch - 'check water' light is on) ?Hi, so, my dishwasher from Bosch (SMS40T32UK) (which I've had for about 5 months now) has been filling with water recently. It doesn't just happen once, it is almost every time I use it that this issue occurs. I live on the 21st floor and the water pressure is either high or not at all there, and it jumps between the two randomly. I was wondering if that could have any effect on it. I read some similar issues and people say to tilt the dishwasher, but that is impossible since there is a work surface above it in my kitchen. Currently, running the cleaning cycle again after the check water light turns on seems to do the trick, but it is only a temporary solution. Any suggestions will be highly appreciated. Thanks.
Jack Cross April 2017
|
 |
 |
Click here if you can answer this question |
 |
 |
 |
 |
 |
It works!! I have Bosch slimline classixx . Tipped half a bottle of limescale remover and bit of boiling water into dirty water in bottom of dishwasher. Next day after reading all the above, I removed the filter and cleaned it, used the Turkey baster and kitchen roll & got ALL the water out of hole, removed the little plastic bit in the bottom(see instruction book) and made sure little wheel spins. There is about 2inch gap between the worktop so I pushed the top of dishwasher back and forwards as much as I could to give it a shake. Ran dishwasher on quick programme, hey presto, is working again!!
Thanks for the tip, has saved me money!
Old bird April 2017 |
 |
 |
|
 |
 |
 |
 |
 |
Some useful tips on the site at this link Jack, good luck.
http://fixed4free.com/answers.php?id=88091
larry 55 April 2017 |
 |
 |
|
 |
 |
 |
 |
 |

Add your answer using the form below ...
|
 |
 |
 |
 |
|
|
 |
 |
 |
|