|
|
|
|
|
|
|
|
|
|
Error Code AL05 on Hotpoint Dish Washer FDW80?My dishwasher is the FDW80, I have an error AL05. The problem started with AL01, the sump was full, so I emptied it, cleaned everything out and now I have AL05. The funny thing is the ‘wash motor’ runs as soon as power is applied to the washer and never stops (even with the display blank), if I then power it ON, and set a program up, the drain pump runs for a while (to empty the already empty machine) then the water starts filling the machine (all the while the ‘wash motor’ is still running. After about a minute the error AL05 appears. As I understand it the error means there is a pressure difference in the system – what would normally be a blocked filter (OR - Pressure switch has not been reset?) – as I have fully cleaned the washer, vacuumed out filter, sump, pipes etc, (with wet vac) it seems to me it must be whatever is sensing the pressures. The Wash pump is free to rotate and runs, the impeller is fixed to the shaft (I have taken the motor out to inspect) – so the question is how does the washer detect the pressure difference? Or, where is the reset button/switch?
Any ideas would be helpful.
Dave April 2019
|
|
|
Click here if you can answer this question |
|
|
|
|
|
If of any help this link is for the user guide,it shows the reset buton on page 11,seems odd thought that your code does signify a blocked filter even after cleaning ...
http://imagebank.indesitcompany.co.uk/brochures_online/pdf/Hotpoint/Dishwashers/FDW80.pdf
robbo 33 May 2019 |
|
|
|
|
|
|
|
|
Add your answer using the form below ...
|
|
|
|
|
|
|
|
|
|
|