Bissell ProHeat stopped spraying solution. It will sorta work when first pull trigger then peters out and stops altogether. Suction seems fine. Solution tank is full....???
mine was doing the same thing, the heater block inside the handle is plgged with deposits from water, take apart the handle (top 2 screws) and remove it, the bottom 2 screws come out and you can split the lower half in 2 pieces..make sure the heater isnt hot anymore.. theres 3 tubes into the heater block that can be plugged, and pull apart the heater (small orings inside) so watch them, clean all the blockage out, and itll work just fine
i FOUND the answer on another site.. so no credit here December 2007
Information posted by users should be considered for general guidance only. Users act, or refrain from action, on the basis of such information entirely at their own risk.
fixed4free.com does not endorse any of the information supplied on this website by users.